| P3 has note
| - Armchair with water-gilded frame, on columnar legs, the seat curved at the front and fully rounded at the back, the back following the rounded plan, with two upholstered panels within <i>piastre-</i>carved frames, the lower frame on each side replicated under the arm, with a long, upholstered panel on the top of each arm rest. The upholstered panels of seat, back and sides are currently covered in yellow silk satin, edged with gimp.
<u>Design</u>
The design is severely neo-classical, with all elements of the back and arms outlined with frames of giltwood carved with <i>piastre</i> (a motif of overlapping circles), the joints between verticals and horizontals each set with a circular <i>paterae</i>, those at the top front of the arm supports ovals. The back and arms are supported on four short, gilded balusters, leaf-wrapped. The seat rail is decorated on the vertical edge with a continuous band of laurel, the centre of the front set with a tablet carved with a reclinging figure of a draped woman, gesturing towards a rectangle that may be a mirror. The chair is raised on four tapering columnar legs, carved with flutes ad set at the top with <i>bucrania</i> or ox skulls, between hanging swags of fruit. The lower end of each legs is held in a cup of upright leaves, above a gadrooned button foot. The chair is water-gilded, the plain fillets highly burnished in contrast to the carved ornament.
<u>Construction</u>
The chair is made of poplar, with four uprights, the back two rising to the top of the back, the front two to the level of the arm-rests and into these are tenoned the rails of the seat and of the back and arms, all the curves cut from the solid. A straight from rail joins the legs, with a further rail of shallow, curved form, attached to it at either end with double pegs (there is no sign of pegging at other joints in the chair). The height of each side rail, the back rail and the front rail is made up of three boards, the lowest only approximately 1 cm high. Marks of scrub planing show vertically on all three. The straight, inner front rail is made of a single board.
From underneath, it is clear that four small boards have been nailed to the top of the rails at each corner. These are approximately 1 cm thick. They create the flat platform around each of the baluster-shaped supports, behind the edge moulding of the seat.
Underneath the seat rails you can see that the fillets on the front edge have been added and it is possible that all the fillets are such additions. The carved decioration, apart from the fluting, is cast in composition and applied. The characteristic cracking across lines of ornament is visible in several places.
<u>Upholstery</u>
The chair retains old webbing, approximately 5 cm wide, that may be its original webbing. This is open set in a fan-shaped pattern to follow the shape of the seat. Above it a linen base cloth is visible, with stuffing ties. The upholstery of the seat must be built on a separate wooden frame (which can be felt at the edges of the pad) and tacked into place on the chair frame, the tacks hidden by gimp. (en)
|
![[RDF Data]](/fct/images/sw-rdf-blue.png)
![[cxml]](/fct/images/cxml_doc.png)
![[csv]](/fct/images/csv_doc.png)
![[text]](/fct/images/ntriples_doc.png)
![[turtle]](/fct/images/n3turtle_doc.png)
![[ld+json]](/fct/images/jsonld_doc.png)
![[rdf+json]](/fct/images/json_doc.png)
![[rdf+xml]](/fct/images/xml_doc.png)
![[atom+xml]](/fct/images/atom_doc.png)
![[html]](/fct/images/html_doc.png)